Pack of 2 Remote Battery Disconnect Switch B78314
Pack of 2 Remote Battery Disconnect Switch B78314
Main parameters: standby current < = 1.5mA, continuous on-off capacity: 100-120a, instantaneous on-off capacity: 1200A (less than 2 seconds), working voltage: 9-18v（A remote control is provided as standard).Other parameters can be adjusted through the menu (see the manual for specific operation)
The integrated design of the whole switch, you only need to connect it in the middle of the line that needs to be turned on and off. It can be connected to the positive pole or the negative pole, which is very convenient
OLED display screen can display battery voltage, battery capacity, switch status and other information in real time.There are also bright LED indicators on its side. When the switch is closed and on, it flashes red and green respectively, which is very obvious at night.
Solid state relay: This product adopts all solid state relay internally, with no contact action, no electric spark, no corrosion and rust. It is different from the mechanical contacts of other electromagnetic relays, so its service life is greatly prolonged and its response speed is fast.
【Note: 】] it is not suitable for the side post battery, because the device cannot be fixed on the side of the battery unless you have a way to fix it.The side post battery is the battery post on the side of the battery, not on the top of the battery.(As shown in Figure 5)
Due to airline regulations, batteries are dangerous goods and are not allowed to be transported. Therefore, there is no battery in the remote control. You need to purchase two CR2016 batteries locally and install them according to the picture instructions.
For leakage cars, the battery voltage will continue to decrease. When the battery voltage is lower than 12V, the equipment will automatically cut off the line. 12V is the factory value of the equipment. This voltage can be reset through parameters. For example, you can set your minimum disconnection voltage to 11.5V. The setting method is described in detail in the manual.
The working voltage of the equipment is 9v-18v. This data is obtained by the laboratory and is accurate and reliable. That is to say, even if the battery voltage drops to 9V, the equipment can still work normally.
If you still have any questions you don’t understand when installing the device, you can Q&A or send me an email. We will guide the installation throughout.
Main parameters: standby current <= 1.5mA, continuous on-off capacity: 100-120a, instantaneous on-off capacity: 1200A (less than 2 seconds), working voltage: 9-18v